Cement Mixer - 240V

Belle 240V Cement Mixer
Belle 240V Cement Mixer
Belle 240V Cement Mixer Hire
Belle 240V Cement Mixer Stand
Belle Minimix 150 240V 16A Socket Mixer

Ideal for both DIY and professional applications, mixing a full wheelbarrow load of concrete or mortar.

Supplied complete with a 240V RCD Power Breaker and Stand.

Additional Information:

Mixing concrete or cement by hand is very labour intensive and is only really suitable for small quantities, mixing with a mixer is much easier and quicker allowing larger quantities to be produced in a relatively short time. At Hire Station we only have Belle Mixers in our hire fleet which are built for durability and are the number one choice for mixers worldwide. The mixers have full thermal overload protection as well as a NVR (no-volt-return) safety power switch. Used with its stand these highly portable, lightweight and quality machines allow barrow height mixing and tipping.


Technical Information:

  • Based On: Belle Minimix 150
  • Power: 240 Volt (16 Amp Plug)
  • Drum Capacity (litres): 130
  • Mix Capacity (litres): 90
  • Power (hp / Kw): 0.75 / 0.55
  • Drum Speed (rpm): 24
  • Noise Level (dB): 107
  • Dimensions: Width x Height x Length (mm): 597 x 890 x 1211
  • Weight without stand (kg): 55

How To Use The Mixer:

It is important that the mixer is stood on firm level ground so that it cannot tip over whilst in use and is close to a water supply. Set up the mixer so that the drum is at a 45 degree angle and turn on the machine. Start by adding half of the sand, half of the ballast and a little water and allow the mixer to mix this for a few minutes before adding the cement followed by the rest of the sand and ballast. After a few minutes start adding some more water, a little at a time until the required consistency is reached (observe the mix as it travels around the drum and note the point at which it drops, if the mix reaches the top before dropping, then it is too dry, if the mix doesn't reach the side as it turns, it is too wet). A good consistency will travel half way up the side of the drum before dropping, if it is too dry, there will be no flow and the concrete will not fill the area properly, if it is too wet, the mortar will flow out of the mix. When the mix is ready, position your wheelbarrow in front of the mixer, then tilt the drum slowly to load the wheelbarrow. Do not allow the mixer to dry before cleaning it (dried concrete is hard to remove from a mixer drum). Put a small amount of sand into the drum with plenty of water and leave it to run for a few minutes then empty, and then follow this with just water to clear the remainder off. Switch off the mixer and if required, use a stiff brush to clean the blades.


Concrete And Mortar Mixes:

There are several different mixes that can be employed. The proportions of each individual element added are dependent on the project. A strong concrete mix is one with a higher percentage of cement, whilst a weaker mix uses less.

General Purpose Concrete = 1:2:3 mix. Ideal for most uses except foundations and exposed paving. It is composed of one part cement, two parts sand and three parts coarse aggregate (if using a combined aggregate, this mix would be 1:4, one part cement to four parts combined aggregate).

Foundation Concrete = 1:2 ½:3 ½ mix. Ideal for wall foundations or bases and laying paving slabs, etc. One part cement, two and a half sand and three and a half coarse aggregate (if using a combined aggregate, this mix would be 1:5).

Paving Concrete = 1:1 ½:2 ½ mix. Used for exposed paving such as driveways and garage floors. One part cement, one and a half parts sand and two and a half parts coarse aggregate (a combined aggregate would need a mix of 1:3 ½).

Standard Mortar = 1:5 mix.Used for internal or sheltered bricklaying. Mix one part cement to five parts soft sand. Add a small amount of lime or one part plasticizer to increase the workability (this type of mix is ideal for an internal block partition wall).

Strong Mortar = 1:4 mix. Used for exposed brickwork. Mix one part cement to four parts soft sand, add a small amount of lime or plasticizer to increase the workability.

Everyday Hire Guarantee Product 240V Item RCD Power Breaker Required Hearing Protection Required Hand Protection Required Foot Protection Required Item Can Be Transported By Box Van Available For Collection From Branch Available To Order Online Order By Phone 0370 99 00 999
Code 070005
Item Cement Mixer - 240V
Same Day £18.26
+ Day £5.94
Weekend £23.98
Weekly £29.70

Useful Information

Branch locations
Aberdeen
Ashford
Barnsley
Bradford
Birmingham
Brighton
Bristol
Canning Town
Cannock
Canterbury
Cardiff
Carlisle
Chessington
Chesterfield
Colchester
Coventry
Croydon
Dartford
Derby
Edinburgh
Exeter
Folkestone
Gateshead
Gillingham
Glasgow
Greenford
Heathrow
Hull
Leeds
Leicester
Liverpool
Long Eaton
Loughborough
Maidstone
Manchester
Mansfield
Margate
Melton Mowbray
Middlesbrough
Newcastle
Northfleet
Norwich
Nottingham
Peterborough
Plymouth
Sheffield
Shrewsbury
Sittingbourne
Skipton
Southampton
Stevenage
Stoke
Strood
Swansea
Telford
Tonbridge
Tower Bridge
Warrington
Aberdeen
Ashford
Barnsley
Bradford
Birmingham
Brighton
Bristol
Canning Town
Cannock
Canterbury
Cardiff
Carlisle
Chessington
Chesterfield
Colchester
Coventry
Croydon
Dartford
Derby
Edinburgh
Exeter
Folkestone
Gateshead
Gillingham
Glasgow
Greenford
Heathrow
Huddersfield
Hull
Leeds
Leicester
Liverpool
Long Eaton
Loughborough
Maidstone
Manchester
Mansfield
Margate
Melton Mowbray
Middlesbrough
Newcastle
Northfleet
Norwich
Nottingham
Peterborough
Plymouth
Sheffield
Shrewsbury
Sittingbourne
Skipton
Southampton
Stevenage
Stoke
Strood
Swansea
Telford
Tonbridge
Tower Bridge
Warrington
Order and Collect

Order & Collect

Please note

Our order and collect service is available on all orders placed online, on the phone or in the local branch. However, you may not get the same special offers and prices as advertised on this site.

Our branch staff will show you how to use the machine in the branch, but please also note the hirer should collect so he / she knows how to use the equipment.  If you are collecting from us on behalf of someone else, please be aware we cannot be held responsible for any operating errors or faults.

When collecting from a local Hire Station branch please make sure you take two forms of ID and one must be photographic.  Hire Station may also require a deposit when you collect, so please ensure you take a credit card. Deposits will of course be returned when you return the item back to the branch.

You can return the equipment you hire to ANY Hire Station branch.

Awards & Accreditation